OCI Networking implementing VPN Connect and Private Load Balancer Access
I'm not sure how to approach I can't seem to get I need some guidance on I'm currently working with an scenario where my VPN Connect is set up correctly, but my private load balancer in OCI is not accessible from my on-premise network..... I've configured the VPN using the OCI console and it seems to be connected successfully according to the status, but requests to the load balancer are timing out. Here’s a snippet of my VPN configuration: ```json { "tunnel": { "ikeVersion": "IKE_VERSION_2", "ikeCiphers": ["AES256-SHA256"], "ipsecCiphers": ["AES256-SHA256"], "pfs": "PFS_14" }, "bgp": { "localAsn": 65000, "peerAsn": 65001, "bgpCidr": "10.0.0.0/24" } } ``` I've verified that the routing table associated with my private subnet has the following routes: - Destination: `0.0.0.0/0` Target: `VPN Tunnel` - Destination: `10.0.0.0/24` Target: `Local VCN` And the security lists for the load balancer look like this: - Ingress Rule: All Traffic from `10.0.0.0/24` - Egress Rule: All Traffic to `0.0.0.0/0` I’ve checked the logs on my on-premise firewall and can see that packets are leaving, but there’s no response coming back. I tried using tools like `ping` and `traceroute`, and it seems like the packets don’t even reach the load balancer. Could this be related to the NAT gateway settings or the configuration of the load balancer itself? I also suspect it might be related to the security policies on the load balancer which I haven’t explicitly defined. Any advice on how to debug this scenario further or potential configuration adjustments would be greatly appreciated! Is there a simpler solution I'm overlooking? Thanks for any help you can provide!